Gateway solo notebook hard drive lifegard tool




















The main hard drive kit is located beneath the 3. Remove the two screws that secure the hard drive kit to the notebook. Slide the hard drive kit away from the connector. Lift the end of the hard drive kit remove the kit from the bay. Remove hard drive caddy from hard drive, re-use it on the new hard drive 9. Place the new hard drive kit in the bay and slide it into the connector.

Replace the two screws to secure the hard drive kit to the notebook. Reinstall the 3. Insert the battery, connect the AC adapter, modem and network cables, and turn on your notebook.

Note: All hard drives listed on this page are bare drives only. You need re-use the orignal hard drive caddy or buy a new hard drive caddy. Home BiXPower. So, is there an easier way to perform Gateway laptop hard drive upgrade without reinstalling Windows? Sure, you can transfer all data including Windows OS and other apps from the old hard drive to the new one through cloning the hard disk. So, what's the best disk clone tool for upgrading Gateway laptop hard drive?

So the destination disk should be bigger than the source disk. Uninstall unnecessary programs or files that you don't want to transfer to the destination disk. Step 5. Step 6. You will receive a boot note on how to boot from the cloned hard disk. Step 7. This process will be performed under the PreOS mode when it involves the operating system. After the clone is finished, you can take the following steps to remove the Gateway laptop hard drive, install the cloned disk and boot from it.

Remove the screws securing the hard drive cover to the base. Pry the hard drive cover off with a spudger. Pull the hard drive caddy tab to the right. Lift the old drive up about 30 or 45 degrees and pull it out.



0コメント

  • 1000 / 1000